Not stable M4 with new firmware 1.8

I just upgraded six Deco M4 from 1.6 to 1.8. After running some days, the network becomes unstable and not giving out IP addresses. I was running the network for years without any problems. I need to reset the main Deco (and the ISP router!) in order to get it up and running again.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content

Hi, thank you very much for the feedback.
Did Deco M4 turn red during the disconnection?
Could you please refer to this link to check which one is quite like your case?
Fix unstable connection when connected to the Deco network
If it occurred on some devices only, can I have the model numbers of these clients?
Can I also have a picture of the current network map, such as:
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content

Hi, thank you very much for the feedback.
Did Deco M4 turn red during the disconnection?
Could you please refer to this link to check which one is quite like your case?
Fix unstable connection when connected to the Deco network
If it occurred on some devices only, can I have the model numbers of these clients?
Can I also have a picture of the current network map, such as:
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content

Information
Helpful: 1
Views: 77
Replies: 1
Voters 1
