ER707-M2 v1.20 fails to reconnect with dynamic IP

ER707-M2 v1.20 fails to reconnect with dynamic IP

ER707-M2 v1.20 fails to reconnect with dynamic IP
ER707-M2 v1.20 fails to reconnect with dynamic IP
a week ago
Model: ER707-M2  
Hardware Version: V20
Firmware Version: 1.3.0 Build 20250512 Rel.61917

Hey guys,
Im not sure if im missing a setting somewhere but recently i changed some settings with my isp.
my old ax55 would reconnect when my NTD reset.
this time i waited about 30 min before i realized that my wan connection hadn't detected that it was down,
i had to click disconnect then reconnect to get back online.

i have an online detection interval of 2 min, but im not sure if there's any other settings in relation to this.
just concerned that if im not on location and my dynamic ip changes the only way to fix this is a manual reboot or to login locally and click the disconnect then reconnect buttons.
 

  0      
  0      
#1
Options
2 Reply
Re:ER707-M2 v1.20 fails to reconnect with dynamic IP
a week ago

  @Hobba 

I am not sure what settings you have changed as you did not describe it. 

If that was working before, and you changed something. Consider reverting the settings you have made. 

It could be a misconfig with your WAN settings which leads to the problem now. 

  1  
  1  
#2
Options
Re:ER707-M2 v1.20 fails to reconnect with dynamic IP
a week ago

  @Clive_A the mentioned settings changed were with my isp, and in order to enable these settings the connection needed to be reset on their side.

default settings were left on the gateway and this is where the problem was noticed, even though there was no network access the gateway still showed online status and didnt attemt to reconnect.

  0  
  0  
#3
Options