NZ200 AC
is it possible to change the operation mode for this device to be as an access point, the operation mode opetion is not showing.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
Currently, Archer NX200 mainly supports working in 5G router and Wireless Router mode. It seems to be a waste to set it as an Access Point.
Would there be any specific reason you want to set it into Access Point mode?
There is no "Access Point" mode on the admin UI, but if you're interested, you can refer to Case two here to see if you can manually configure it into Access Point mode:
https://www.tp-link.com/en/support/faq/1384/
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
Currently, Archer NX200 mainly supports working in 5G router and Wireless Router mode. It seems to be a waste to set it as an Access Point.
Would there be any specific reason you want to set it into Access Point mode?
There is no "Access Point" mode on the admin UI, but if you're interested, you can refer to Case two here to see if you can manually configure it into Access Point mode:
https://www.tp-link.com/en/support/faq/1384/
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 87
Replies: 1
Voters 0
No one has voted for it yet.