Kevin_Z wrote

Hello @Matheus-Alfanet, thanks for posting in the community.

 

Can I have the following information before we proceed with the investigation?

1. Where did you buy this XX530v V2, from a local reseller or was it provided by your ISP (Internet Provider)?

2. Who is your ISP?

3. How do you configure on your ZTE OLT about the WAN connection which contains the IPV6 connection？

 

Have you tried to contact the reseller or the Internet Provider or our local technical support? Would you be able to get technical support or advice for this reported IPv6 issue?

  @Kevin_Z I think @Matheus-Alfanet works for an ISP. He isn't a customer.

  @Kevin_Z 

Good morning, sorry for the delay in responding.

We are from ISP Alfanet, located in Paraná, Brazil.

We purchased the XX530 v2 from an authorized supplier in the region, where we always buy TP-Link products.

We used this command for authorization witch OMCI: 

conf t
interface gpon_onu-1/[[slot]]/[[pon]]:[[indice_onu]]
name [[descricao]]
description gpon_onu-1/[[slot]]/[[pon]]:[[indice_onu]]
tcont 1 profile TCONT-[[planos]]
gemport 1 tcont 1
exit
interface vport-1/[[slot]]/[[pon]].[[indice_onu]]:1
service-port 1 user-vlan [[vlan]] vlan [[vlan]]
exit
pon-onu-mng gpon_onu-1/[[slot]]/[[pon]]:[[indice_onu]]
service internet gemport 1 vlan [[vlan]]
wan-ip ipv4 mode pppoe username [[login]] password [[senha]] vlan-profile PROFILE-VLAN-[[vlan]] host 1
vlan gemport 1 mode trunk
vlan gemport 1 vlan [[vlan]]
security-mgmt 1 state enable mode forward protocol web https
security-mgmt 2 state enable mode forward ingress-type lan protocol web https
end
write

This command worked correctly on the XX530 v1 and XX230, activating both IPV4 and IPV6, but on the XX530 v2 it only activates IPV4.