IPv6-Only Configuration on TP-Link MR600 with Starlink?
Hi everyone,
I'm trying to configure my TP-Link MR600 to use only IPv6 with Starlink. However, when I turn off IPv4 on the MR600 to force it to use IPv6 exclusively, I lose my internet connection entirely.
Starlink supports IPv6, so I’m not sure what’s causing the issue. Has anyone successfully set up an IPv6-only connection on the MR600 with Starlink? If so, could you share any settings or steps that worked for you?
Any help would be appreciated!
Thanks!
Hi, do you plan to set Archer MR600 as a Wireless router, instead of the 4G router?
Starlink often provides a WiFi router in the service package. Did you connect the Archer MR600 behind the Starlink router?
-If yes, it is suggested to set the IPV6 connection type to "Pass-Through(Bridge)"?
Thank you very much.
Best regards.