Frequent connection problems to Archer NX600 from Tether App
I have these two devices forming one EasyMesh network. Both are SW updated.
ID Device Name Model Name Firmware Version Latest Firmware
1 Archer NX600_A027 Archer NX600 1.1.0 3.0.0 v60c8.0 Build 240822 Rel.78050n --
-2- RE700x V1.0_8395 RE700X V1.0 1.3.10 Build 20250817 Rel. 63070 --
But i am detected in my recently bought Archer NX600, that connections from Tether App fails with a high ratio (higher than 50%) and with different messages (Connection not possible, wrong password, etc.) If i reattempt,
I could finally establish the connection. Also when connection is established, the ratio of lossing connection is quite high.
This problem is not happening from same mobile-tether app with the other device RE700X.
Do you have reference of this problem?
Thanks.
@Jabato Hi, thank you very much for your feedback.
The connections from Tether App fails with a high ratio (higher than 50%) and with different messages (Connection not possible, wrong password, etc.) If i reattempt.
-Can I have some screenshots of the error message?
-"The connection", did you refer to the process from clicking the model number to entering the advanced settings of the router?
(It would be very helpful if you could record a short video clip of the whole process
)
Thanks a lot.
Best regards.
Connection is from Tether App for accessing to the advanced settings of my device.
I have a 5 minutes video where you can see the irregular that are the connections to my Archer NX600 compared with the other RE700X device, that never fails.
But only 10MB files are allowed here and my video is larger. If there would be one way to upload 46MB, i can try to share it.
Some screenshots of errors that appeared several times during those 5 minutes...
Thanks.