NFilipek wrote

In Tether app i have only one mesh togle when connected to RE450. As it have a firmware that support easy mesh it should have that togle too.

 

  @NFilipek 

Hi,

This is a known bug that hasn't been fixed yet. (for over two years)

The "EasyMesh" is properly shown in the RE450's web management interface, though.

Anyway, here is a screenshot showing TP-Link's instructions on how to connect a range extender like the RE450 V4 to an EasyMesh router.

  @woozle  Thank you. Do you know if tp link extender should be factory reseted before doing that?

  @NFilipek 

Normally, a factory reset should not be needed before adding the extender via WPS.

But I usually do a factory reset anyway, because I don't like to take the risk of running into any unforeseen issues that may have gone unnoticed during TP-Link's testing.