Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0

< Wi-Fi Routers

EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0

Leandro_Sampa

2025-11-18 15:22:29 - last edited 2025-11-19 02:47:29

Posts: 3

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2025-11-18

EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0

2025-11-18 15:22:29 - last edited 2025-11-19 02:47:29

Tags: #EasyMesh

Model: Archer AX53

Hardware Version: V1

Firmware Version: 1.4.4 Build 20250603 rel.74380(4252)

I have two Archer 53 units running an EasyMesh network. I configured the satellite as a router and connected them via cable using both the LAN and WAN ports, but Ethernet backhaul does not work. In the post https://community.tp-link.com/en/home/forum/topic/593722 it is stated that the feature is supported. Is there any solution?

1 Accepted Solution

woozle

LV6

2025-11-18 15:55:42 - last edited 2025-11-19 02:47:29

Posts: 4048

Helpful: 2788

Solutions: 898

Stories: 0

Registered: 2020-05-01

Re:EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0-Solution

2025-11-18 15:55:42 - last edited 2025-11-19 02:47:29

@Leandro_Sampa

Hi,

Since there is no connection detected on any of the four LAN ports (in "Status da Ethernet"), there is most likely a problem with the Ethernet cable you are using.

Please replace the Ethernet cable between the two Archer AX53 with another one. Also try all four LAN ports.

In case you have a network switch or similar device between the two Archer AX53, then please remove it for testing.

Recommended Solution

3 Reply

Leandro_Sampa

LV1

2025-11-18 15:27:28

Posts: 3

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2025-11-18

Re:EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0

2025-11-18 15:27:28

@Leandro_Sampa

woozle

LV6

2025-11-18 15:55:42 - last edited 2025-11-19 02:47:29

Posts: 4048

Helpful: 2788

Solutions: 898

Stories: 0

Registered: 2020-05-01

Re:EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0-Solution

2025-11-18 15:55:42 - last edited 2025-11-19 02:47:29

@Leandro_Sampa

Hi,

Since there is no connection detected on any of the four LAN ports (in "Status da Ethernet"), there is most likely a problem with the Ethernet cable you are using.

Please replace the Ethernet cable between the two Archer AX53 with another one. Also try all four LAN ports.

In case you have a network switch or similar device between the two Archer AX53, then please remove it for testing.

EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0

EasyMesh Network via Ethernet Backhaul with Archer AX53 v1.0

Information

Voters 0

Tags