Hi TP-Link Community,

I have two TP-Link Aginet XPON routers, purchased online in India (not ISP-provided):

• XX530v (v1.8_0.7.0_3.0.0 Build 250606) – planned as the main router, connected directly to the fiber (PON).

• XC220-G3v (V2_1.14.0_0.8.0 Build 250317​​​​​​​) – planned only to extend Wi-Fi coverage.

Both devices mention Aginet / EasyMesh compatibility, so I would like to confirm whether the following setup is officially supported.

What I want to do

1. Connect XX530v directly to the fiber line and use it as the main router / EasyMesh controller.

2. Place XC220-G3v in another room and connect it wirelessly to the XX530v (no Ethernet cable).

3. Use XC220-G3v as a secondary EasyMesh node / satellite (same SSID, seamless roaming).

4. The XC220-G3v will not act as a router (no NAT / no DHCP / no double NAT).

My questions

1. Can XC220-G3v join an EasyMesh network as an agent / node under XX530v?

2. Does this setup support wireless backhaul, or is EasyMesh supported only with wired backhaul for XC220-G3v?

3. What is the correct pairing method?

   • EasyMesh “Add Node” option

   • WPS pairing

   • Any specific “Agent / Node mode” setting on XC220-G3v

4. After pairing, can WPS be disabled while keeping the mesh working normally?

5. Are there any firmware, hardware version, or region limitations for XC220-G3v V2 acting as an EasyMesh node?

Goal

Stable internet on the main router with extended Wi-Fi coverage using EasyMesh, without running LAN cables.

Country: India

Thanks in advance for your guidance.