Deco X20-DSL connecting to TVT SuperCamPlus
Can not seem to get iPhone to connect through Deco X20-DSL to TVT DVR with follow port settings
HTTP Port = 80
Device Port = 6036
RTSP = 554
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, if you plan to open ports for remote access, please refer to this link to make sure the IPV4 address on the Deco X20-DSL is the same as the IP displayed on https://whatismyipaddress.com/.
Best regards.
- Copy Link
- Report Inappropriate Content
Both IPv4 addresses do appear to be the same, but still no joy
- Copy Link
- Report Inappropriate Content
Hi, thanks for the feedback.
When the iPhone is also connected to the Deco WiFi, will it be able to access the TVT DVR in the local network?
I checked the video link here, and it seems port forwarding is not needed:
https://www.youtube.com/watch?v=wgz2-REBLzk
Did you get any official documents about how to remotely Aaccess to TVT SuperCamPlus?
Best regards.
- Copy Link
- Report Inappropriate Content
Have also tried a Deco X53-DSL with same results.
I can access the TVT DVR via web browser on pc OK with Ethernet connection to Deco
The TVT DVR is connect bt Cat6 to LAN1 port ob the Deco X53=DSL
The Supercam can access TVT DVR if iphone and TVT DVR on same wifi
No luck when access Supercam when wifi off.
Have tried NAT Port forwarding with no luck
Starting to loss faith in this setup
It used to work ok but reset system by mistake when adding addition Deco X20 modules
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 49
Replies: 4
Voters 0
No one has voted for it yet.