Deco P7 limits the speed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco P7 limits the speed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco P7 limits the speed
Deco P7 limits the speed
2020-02-28 19:21:36 - last edited 2020-02-28 19:26:30
Model: Deco P7  
Hardware Version:
Firmware Version: 1.3.1 Build 20190704 Rel. 46693

Hello!


I have a setup of three Deco P7 units.


My provider gives me 100 mbps and I see that speed on my devices but after some time it limits to ~10 mbps. Only restart helps.
I have several devices and they are connected to different units. One is connected with ethernet cable, another is connected via wifi. They both show same behaviour.
When I restart the unit, speed goes up for a bit of time and then goes down again.

 

If I perform a speedtest within a Deco app, it reports with the normal 100mbps speed, but connected devices are working very slow. And I have a feeling that it is happening only on one of the three units.

 

It started only several weeks ago.

 

Thank you!

  0      
  0      
#1
Options
1 Reply
Re:Deco P7 limits the speed
2020-03-02 02:25:10

@qst 

 

Thanks for your information, we can do some troubleshooting to locate this issue and try to figure it out. 

 

1. When the speed slows down to 10Mbps, please check the speed you can get from main Deco by wired cable and wireless respectively. And you can test the speed from the two slave Decos one by one. 

2. You can power on the main Deco only first and take some time to test its performance, and then you can add the slave Deco gradually and locate the issue.

3. You can adjust the location of the Decos or swap them; and you can switch the slave Deco to main Deco and give it a go. 

https://www.tp-link.com/support/faq/2400/

 

Thanks a lot. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1080

Replies: 1

Related Articles