Deco app - to remove a smart device from automation status

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco app - to remove a smart device from automation status

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco app - to remove a smart device from automation status
Deco app - to remove a smart device from automation status
2020-06-03 09:29:18 - last edited 2020-06-03 10:44:11

I have many TP-Link Deco units and recently when adding a new TP-link smart plug HS100 to the mesh the app automatically sets the new unit as automation unit. So now I have many HS100 smart plus in the app as normal devices and new ones are in different category.

 

I only use the Deco app to control my network and I do not want it to control any way my automation - I have way better means to do that. 

 

So how can I remove this "automation device" status from these new smart plugs to get them shown in the app just like all the other devices connected to my network?

 

I

  1      
  1      
#1
Options
4 Reply
Re:Deco app - to remove a smart device from automation status
2020-06-04 11:43:33

@just_me 

Hi, 

Yes, you can remove the HS100 from the "automation device" status, and then it will show in the app like all other devices.

  0  
  0  
#2
Options
Re:Deco app - to remove a smart device from automation status
2020-06-04 13:10:18 - last edited 2020-06-04 19:21:47

@TP-Link_Deco 

 

Thanks a lot for a response!

 

My question was how and unfortunately your answer does not explain that.

 

So if you know how you change the status to "general/not automation" device could you please try to explain how it happens; I have tried that but have not found the way?

 

 

  1  
  1  
#3
Options
Re:Deco app - to remove a smart device from automation status
2020-06-05 08:50:04

@just_me 

You can follow the instruction in the attachment for a try.

 

File:
How to remove a smart device from the Deco app's smart device list.docxDownload
  0  
  0  
#4
Options
Re:Deco app - to remove a smart device from automation status
2020-06-05 11:17:44

@just_me 

 

OK - thanks!

 

I worked - I saw that also myself, but never tried that, because I was afraid it will move the device from the mesh also. The devices are far away and I operate remotely, so if removed from the mesh I could not rejoin them again remotely.

  0  
  0  
#5
Options

Information

Helpful: 1

Views: 1487

Replies: 4

Related Articles