Mesh omada eap’s and ax 6000 router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I heve 2 EAP's binded in mesh with omada controller. Can I make my router AX 6000 part of thr omada controller? So the ssid are all the same and in mesh?
By the way is it wise to name ssid all the same 2.4 and 5gh?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
AX6000 doesn't support Onemesh yet and this needs to be supported by the future firmware.
Most importantly, the TP-Link OneMesh™ router, such as AX6000 can only be combined with OneMesh™ RE or OneMesh™ PLC to build Mesh networks, it will not be able to build the mesh network with the EAP devices.
However, this AX6000 is compatible with the EAP network and you can set the same name for both the 2.4G and 5G.
Thanks.
- Copy Link
- Report Inappropriate Content
Hello,
AX6000 doesn't support Onemesh yet and this needs to be supported by the future firmware.
Most importantly, the TP-Link OneMesh™ router, such as AX6000 can only be combined with OneMesh™ RE or OneMesh™ PLC to build Mesh networks, it will not be able to build the mesh network with the EAP devices.
However, this AX6000 is compatible with the EAP network and you can set the same name for both the 2.4G and 5G.
Thanks.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1479
Replies: 1
Voters 0
No one has voted for it yet.