Regarding setting up My Deco Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Regarding setting up My Deco Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Biscuit

2020-08-21 13:52:44 - last edited 2020-08-27 03:39:22

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-08-21

Regarding setting up My Deco Router

2020-08-21 13:52:44 - last edited 2020-08-27 03:39:22

Model: Deco M4

Hardware Version:

Firmware Version:

Hello,

I've been using Tp Link TL-WR840N for a very long time and I wanted to upgrade my router and want to buy TP Link Deco M4.

My question is, since Deco M4 has 2 ports, Is it possible to connect my ethernet line to port 1 as wan port and and use the 2nd one as lan port to directly connect to my Desktop? So far, all the tutorial shows that I have to connect my Deco to an existing router but there is no information regarding using Deco as main device.

Thanks In advance.

1 Accepted Solution

David-TP

2020-08-27 03:39:18 - last edited 2020-08-27 03:39:22

Posts: 12841

Helpful: 1806

Solutions: 1298

Stories: 9

Registered: 2020-04-14

Re:Regarding setting up My Deco Router-Solution

2020-08-27 03:39:18 - last edited 2020-08-27 03:39:22

@Biscuit

Hello,

Yes, you may connect the main Deco M4 to your existing modem to replace the WR840N and set it up as a Router, once the setup finished and the internet is on, then connect a wired device to the other LAN port to access the internet.

Below is the guide to install the main Deco:

https://www.tp-link.com/support/faq/2464/

May it help.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

Recommended Solution