I am not seeing my Extender after set-up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I am not seeing my Extender after set-up

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am not seeing my Extender after set-up
I am not seeing my Extender after set-up
2020-09-18 12:14:02
Model: RE450  
Hardware Version:
Firmware Version:

After setting up my Extender with my android mobile phone I an not seeing it listed under wifi on either my phone or laptop even though all the 4 LED lights are solidly on (in blue colour). Why?

 

2.  Is it possible to link or connect 2 routers (from 2 different internet service providers) one being run at 2.4GHz and the other on 5.0GHZ at the SAME time to this extender See picture below)?

 

  0      
  0      
#1
Options
1 Reply
Re:I am not seeing my Extender after set-up
2020-09-21 10:39:15

@CollinsGhana 

Good day.

Sorry for the delay.

It is not available to set up RE with two routers since RE did not support multiple IP ranges;

For the SSID issue, did you set up RE via the WPS button, or copy the SSID of the home router during the setup?

If yes, please refer to the following instruction:

  1. Connect a computer via Ethernet cable to the RE450;

(if there is no wired computer, please unplug the router for a while to check if there is still the home router SSID; if it was, it much be the RE450;)

  1. Log into the RE450 via http://tplinkrepeater.net
  2. Change the SSID under settings>wireless>extended network;

Thank you very much.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 431

Replies: 1

Related Articles