Archer C7 router mode - pppoe disconnect
Hello all,
i have an archer c7 v5 model which i have recently upgraded to the firmware version 201030. It worked for aprox one week and then the pppoe connection got disconnected and I was not able to connect it back to my ISP. The router works if i set it to access point mode but it does not work in the router mode. I have even reset the router but it is still not able to connect via pppoe. I want to mention that it is working fine if i put my other router (assus rt-n53 as main router) and tp-link is in access point mode. One last thing i need to mention that when tp-link router is is router mode the system time is set to 30.10.2020
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Ivaylo it is working as we sprak. I have the following setup
Tplink is in router mode - pppoe connection to ISP
Assus is in access point mode - connected via LAN to tplink and working as wifi range extender
Ivaylo wrote
Have you tried to tweak these settings (Advanced=>Network=>Internet, scroll down and select Advanced):
- Copy Link
- Report Inappropriate Content
Have you tried to tweak these settings (Advanced=>Network=>Internet, scroll down and select Advanced):
- Copy Link
- Report Inappropriate Content
Just to confirm, when you dial up on the Archer C7 router, is the assus rt-n53 still in use? Or this Archer C7 is replacing that assus rt-n53? You may try to access the assus rt-n53 web interface and write down the WAN MAC address, then copy it to the WAN of the C7 to give it a try. Here are the steps shared by other customers.
You can also try Ivaylo's suggestions.
- Copy Link
- Report Inappropriate Content
@Ivaylo it is working as we sprak. I have the following setup
Tplink is in router mode - pppoe connection to ISP
Assus is in access point mode - connected via LAN to tplink and working as wifi range extender
Ivaylo wrote
Have you tried to tweak these settings (Advanced=>Network=>Internet, scroll down and select Advanced):
- Copy Link
- Report Inappropriate Content
@Kevin_Z thanks for support
When i dial up on tplink assus router is working on access point mode(i need it to extend the wifi range). At this point it is working fine(i followed the advice from @Ivaylo to configure the internet connection in advance mode). I will monitor it and let you know it works
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Unfortunately, the pppoe got disconnected again on my tp-link archer C7 v5 router. It worked fine since our last discussions but now i am unable to connect again. Can you please provide a route forward to troubleshoot? see my current configuration below
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 983
Replies: 6
Voters 0
No one has voted for it yet.