Deco M4 select signal source
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I got 3 deco M4 device, 1 as main (AP mode) and slave 1 and slave 2.
Main deco and slave 1 are located at ground floor while slave 2 is located at floor 1.
Main deco is located under the stair so the signal strength is weak a bit, but the speedtest done when client device connect to slave 1 still good.
Problem here is slave 2 connect to main deco instead of slave 1 when slave 1 have greater signal strength compare to main deco.
I saw another post Deco M5 source signal selectable? got release beta firmware for M5 model.
May i know when will m4 beta firmware release? or does it have any other temporary solution?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I am having the same problem with 3x Deco M4R V2 units.
Could I receive the beta firmware from someone?
It is 6 months old now, still no official release?
I've got the main deco in the front of the house on the first floor.
Second deco on the back of the house on the third floor, connected using the ethernet backhaul.
The third deco is located in the back of the backyard. The signal there is receoved best from deco 2, but it is connecting through deco 1...
- Copy Link
- Report Inappropriate Content
Is there any link to get this beta firmware, otherwise is there anyone who can send it please?
thank you!
- Copy Link
- Report Inappropriate Content
Hi All，
Currently, We are working on the firmware that supports selecting signal sources manually.
Please keep an eye on Deco APP and once we release the new firmware, you will get a notification.
For more details, please refer to this link:
[Deco] Manual Signal Source Selection
Thank you very much.
- Copy Link
- Report Inappropriate Content
Thanks for sending me the beta firmware.
So I understand it correctly that it only needs to be installed on the deco unit which is connecting to the "wrong" AP?
On my network it is still connecting to the main deco. So I am wondering if both main and second deco have an equally bad reception at the point of deco 3 and it still chooses the main one?
Does it actually test reception of all deco units or how does it choose the "closest deco node" as you mentioned?
- Copy Link
- Report Inappropriate Content
@TP-Link many thanks it's very appreciated, i ´ll try it
- Copy Link
- Report Inappropriate Content
@Bonusbartus Hi, it would test all the wireless signal strengthen of each Deco unit and choose the strongest wireless signal;
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, for V2
- Copy Link
- Report Inappropriate Content
@TP-Link I'm having the same issue on my M4R, wherein the units aren't connecting to the nearest source. Is there available beta firmware for the M4R as well? Also, when can we expect the source-signal-selection update to roll out? Thanks!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 9
Views: 20078
Replies: 80
Voters 8
