Use deco X60 in one-mesh
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hey,
I have some questions:
1. Is it possible to use Deco X60 with One-mesh technology with vr600 v3 router?
2. To run One-mesh in Deco X60 can I connect via wired or do I have to be connected via Wifi?
Tnx
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi，OneMesh™ and Deco Mesh are totally different technologies used on different TP-Link products, so they are not compatible.
For more details, please refer to this link:
https://community.tp-link.com/en/home/forum/topic/201282
Thank you very much.
- Copy Link
- Report Inappropriate Content
First of all thanks for the quick reply.
Second, if I choose to install RE650 in favor of the One-Mesh is it possible to connect it with a wired connection?
If I choose to install X60, can I connect them wired and still get the Mesh technology?
- Copy Link
- Report Inappropriate Content
Hi, RE650 does not support Onemesh when it is connected via Ethernet cable, only wirelessly connected on range extender mode;
Deco X60 still gets the mesh technology when it is connected via Ethernet cable;
- Copy Link
- Report Inappropriate Content
Thank you.
Can I connect some deco X60 via a switch?
Or should the connection be direct between the units?
- Copy Link
- Report Inappropriate Content
Hi, a switch is ok.
And you could have a look at this link:
https://www.tp-link.com/en/support/faq/1794/
Thank you.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2205
Replies: 5
Voters 0
No one has voted for it yet.