No WIFI, cable OK
I use a Archer C1200. After a reboot, I lost my wifi signal (lights are not on) but kept my signal over the cable. What to do? I have already switched off and on a couple of times
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hello @JvDMy
Thank you for posting on the TP-Link Community.
Can I confirm when did you purchase the router, and when did the issue start to happen? If the signals are not available after the router rebooted, how did you get them back?
Please try restoring the router to factory defaults, then reconfigure it to monitor the connectivity again.
Check and ensure the router firmware is up-to-date.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Great job.
I'm going to mark your reply as the “Recommended Solution” to close this topic so others can also benefit from the solution.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 382
Replies: 3
Voters 0
No one has voted for it yet.