no internet connection when connecting TL-WR940N as range extender mode from host router HUAWEI B818

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

no internet connection when connecting TL-WR940N as range extender mode from host router HUAWEI B818

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
no internet connection when connecting TL-WR940N as range extender mode from host router HUAWEI B818
no internet connection when connecting TL-WR940N as range extender mode from host router HUAWEI B818
2022-08-05 14:50:07 - last edited 2022-08-08 08:08:54
Model: TL-WR940N  
Hardware Version: V3
Firmware Version: 3.16.9 Build 161107 Rel.69553n

I am located in the Philippines and am trying to extend the wifi coverage of a Huawei B818 A254 4G router 3 PRIME to TP-Link TL-WR940N as range extender mode. The TP-Link can detect Huawei and establish a connection (light is blue); however, there is no internet access. What could prevent the TP-Link from connecting directly to the Huawei router? I would be grateful for any help.

  0      
  0      
#1
Options
1 Reply
Re:no internet connection when connecting TL-WR940N as range extender mode from host router HUAWEI B818
2022-08-08 08:17:51

Hello @Sharmane 

 

Thank you for reaching out to us and welcome to the TP-Link community.

 

After you configure the WR940N to connect to the HUAWEI B818 wirelessly, how about the WDS status on the WR940 status page? Please review the configuration guide again and ensure all the wireless settings match the settings on the HUAWEI B818: 

How to configure WDS function on TP-Link Wireless Routers

 

If the WR940N still doesn't have internet, please check if there are any Whitelist settings on your Huawei B818 and be sure the WR940N is on the list. 

 

Most importantly, when building a WDS you should bare in mind that:

"In order to build a successful WDS connection between different devices, it requires that both devices use the same wireless MAC address format. For example, Site A uses 4-address MAC Address format in passive WDS bridge mode, Site B also uses 4-address MAC Address format in active WDS bridge mode.

WDS may be incompatible between different products (even occasionally from the same vendor) since the IEEE 802.11-1999 standard does not define how to construct any such implementations or how stations interact to arrange for exchanging frames of this format.-----From Wikipedia"

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 833

Replies: 1

Related Articles