El power no deja de parpadear

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

El power no deja de parpadear

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
El power no deja de parpadear
El power no deja de parpadear
2022-10-17 12:21:23
Model: RE450  
Hardware Version:
Firmware Version:

Intento configurar el TP LINk, pero el power NO DEJA DE PARPADEAR CONTINUAMENTE, ¿hay alguna solución o se ha estropeado?.

 

I try to configure the TP LINK, but the power DOES NOT STOP FLASHING CONTINUOUSLY, is there a solution or has it been damaged?

  1      
  1      
#1
Options
1 Reply
Re:El power no deja de parpadear
2022-10-18 01:24:27

Hello  @Joni66 

If the power led keeps blinking on the range extender, you could try to factory reset the extender:

RESET: With the extender powered on, use a pin to press the RESET button until most Leds flash once.

 

After factory reset, please check if range extender broadcasts any Wi-Fi SSID like Range Extender, TP-link Extender etc.? 

If range extender responds to a reset or still broadcast the Wi-Fi SSID,   you could install the range extender as instructions here 

Configuration Guide:TP-Link Range Extender Setup (Range Extender Mode)

  0  
  0  
#2
Options