X20 Deco Tp-Link Please Help me

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

X20 Deco Tp-Link Please Help me

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
X20 Deco Tp-Link Please Help me
X20 Deco Tp-Link Please Help me
2022-11-19 17:43:38
Model: Deco X20  
Hardware Version: V12
Firmware Version: I dont know

       I am trying to setup the app to my TP-Link Model X20 but there is a button that says let's begin but then when I go threw it and then it says it should be pulsing blue but for me the entire time it was green so when I click "Why is my LED not pulsing blue?" and I tap green and it says "Deco is registered and all is well." So because it's already set up, how would I skip this section? Also if I keep going threw it says connect and when I connect it just scans and then nothing happens and it asks me to do it over and over again.

 

Please Help 

  0      
  0      
#1
Options
1 Reply
Re:X20 Deco Tp-Link Please Help me
2022-11-21 03:24:12

  @MalloyChi 

Hi, Thank you for the message. Have you seen this link: https://community.tp-link.com/en/home/forum/topic/540178

And can I also have the MAC address of your main Deco?

Best regards.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 253

Replies: 1

Related Articles