Home Network Community > All Threads > Using Deco P9 with existing wired netwrok
< All Threads

Using Deco P9 with existing wired netwrok

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Using Deco P9 with existing wired netwrok

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Using Deco P9 with existing wired netwrok
Using Deco P9 with existing wired netwrok
2023-07-20 15:17:24 - last edited 2023-07-24 03:35:35
Model: Deco P9  
Hardware Version:
Firmware Version:

Hi

I am looking for some help about the best way to set up a Deco P9 mesh.  I have a wired network in my house.  I want to be able to access a wifi printer which will be connected to the Deco Mesh.

 

I have a Now Broadband Router, into which is plugged a Netgear 5port gigabit desktop switch which is used to link to various ethernet outlets around the house and to another 8 port switch in my workshop. 

 

At the moment I have the "prime" Deco unit plugged into the Now router, but I am unable to see the printer (or anything on the wifi network).  Should I plug it into the Netgear 5 port switch?  Is there something else I can try.

 

Any help gratefully received.

 

Thanks

 

Martin

  0      
 
  0      
 
#1
Options
3 Reply
Re:Using Deco P9 with existing wired netwrok
2023-07-21 01:30:52 - last edited 2023-07-24 03:35:35

  @Tesan-Man 

 

Go through this FAQ for more details on the possible topologies using an ethernet backhaul.

If your Now Broadband router has a NAT enabled, you could set the Deco in AP mode to avoid double NAT in your network.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  2  
  2  
#2
Options
Re:Using Deco P9 with existing wired netwrok
2023-07-22 16:25:09
Many thanks - I'll check out the FAQ.
  0  
  0  
#3
Options
Re:Using Deco P9 with existing wired netwrok
2023-07-24 03:47:41

@terziyski  Thank you very much for your suggestions.

 

Hi  @Tesan-Man 
In your network diagram, if you want the device connected to your Now Broadband Router can access the printer connected to the Deco's Wi-Fi,  it's suggested to set the Deco in the AP mode.
Or if you connect the Netgear switch to the Deco rather than the Now Broadband Router, then the devices connected to the switch can access the printer since they are in the same network.

 

Best Regards

 

>>Landscape Mode - Tapo App for Pad. >>Smart Action 2.0 Explore and meet the next level home automation. >>How to position my TP-Link camera for optimal performance.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 409

Replies: 3

Related Articles
Deco P9 on existing P7 network
506 0
Limit on speed when using Deco P9 mesh
295 0
Extending Deco P9 network
1489 0
Routering DECO P-9
525 0
Deco P9 with a VPN
2709 0
Deco P9 with Sonos
1801 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.