Deco X20 slow WiFi hand-over when moving between 3 meshes
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco X20 slow WiFi hand-over when moving between 3 meshes
Hello!
I recently purchased a 3-pack X20 Mesh from TP-Link.
My old Mesh was a P9 which was too slow for fiber-internet up to 250 MBit - it only goes up to 130/150 MBit where the X20 reaches it's full 250 MBit on all 3 meshes.
I am used to seamless handovers of a WiFi connection if I move in the house between the ranges of the 3 meshes of my old P9.
There was never a time where it shortly changes to LTE to move to the next mesh.
With the X20 in fact IT IS losing WiFi connection between changing the meshes!
Firmware is up to date.
I have already set...
- Fast Roaming ON
- Beamforming ON
- In fact I have set everything exactly like on my old P9 - even the meshes are placed on the same spaces.
Are there any known bugs - or even hidden tricks to get this working again?
Kind regards
StA
—
Deco X20 v2 1.2.3-20230906 Build 41655
Active IoT network
