Deco X50: device wired to one Deco is not accessible from other Deco
Dear all,
I have two Deco X50 here, one of them is connected via a LAN cable to the provider's 5G modem (running in bridge mode) and the second one is connected to the first one via mesh.
Additionally I have a Raspberry Pi connected via a LAN cable to the first Deco and Docker is running on this device. I have several LAN IP addresses bound to this Raspi because I need different addresses for different services (PiHole, HomeAssistant, MariaDB, WireGuard, Samba, ...). All the IP addresses are configured statically on the Raspi itself (192.168.1.21 to 192.168.1.25).
Problem: I can reach all the services on the Raspi only if I am connected to the first Deco (the one, to which the Raspi is connected). If I try to access any of the services from a computer connected to the second Deco (the one with mesh), the service is not reachable.
Of course I have set up port forwarding in the Deco app. Unnecessarily I am forced to enter a MAC address for each forwarded port to be able to save. In the background the app adds an address reservation for the IP/MAC combination, which is in my case useless, because the IP address is statically set on the Raspi. By the way: as I do have the same MAC address (from the Raspi's LAN adapter) for all the IP addresses 192.168.1.21 - 192.168.1.25, I deleted the automatically added address reservation from the Deco configuration.
I did all the usual stuff (rebooting, clearing browser cache, different browser, notebook or mobile, ...).
Does anyone of you have an idea, which configuration error I have been made?
Some bonus questions: :-)
(1) In the port forwarding setup, I can add a single port or a port range (xxx-yyy), which is forwarded to the target IP address. Can I also add several non-continuous port numbers like "80,443"? A comma does not work ...
(2) Is there any way to reach the complete configuration via a standard browser on a PC? The 192.168.1.1 site only shows some basic information but offers no way to do configuration. It is quite painful to add all the MAC addresses into the app from the mobile.
Thank you and all the best for 2024,
Chris
PS: I am a bit baffled about the hardware version which I had to enter above. According to the dropdown list there seems to be v1 to v7, on the Deco's type label the only number that looks like a hardware version says "1.2". Is this possible for devices bought one week ago from my LTE provider in Austria?