C2300 setup as network switch and wifi extender

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

C2300 setup as network switch and wifi extender

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
C2300 setup as network switch and wifi extender
C2300 setup as network switch and wifi extender
2024-01-13 10:11:54 - last edited 2024-01-31 08:19:07
Model: Archer C2300  
Hardware Version: V2
Firmware Version: 1.1.3 Build 20230906 rel.41773

Hi all.

I did a search but couldn't see anything which helped.

I have a Virgin media superhub as my internet connection point. This has 4 LAN ports. I have one of these connected  into the internet port on my Archer C2300.

Is there a way to set this up as a network switch so it acts as part of the superhub and doesn't create a sub network? Basically an extension of the superhub?

I turned it into an access point but the LAN port didn't allow my PC to connect to the internet via the LAN ports on the C2300.

 

Thanks in advance.

  0      
  0      
#1
Options
1 Accepted Solution
Re:C2300 setup as network switch and wifi extender-Solution
2024-01-13 10:18:35 - last edited 2024-01-31 08:19:07

  @Apl1970 

 

Archer C2300 v2 supports access point mode. Here's how to configure - Case 1.

You have to connect C2300 the same way as if it's in router mode by its WAN port to the superhub LAN port.

In this mode C2300 LAN port will serve as network switch (extension) to your superhub.

Just make sure that C2300 DHCP server is disable when configured in AP mode.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:C2300 setup as network switch and wifi extender-Solution
2024-01-13 10:18:35 - last edited 2024-01-31 08:19:07

  @Apl1970 

 

Archer C2300 v2 supports access point mode. Here's how to configure - Case 1.

You have to connect C2300 the same way as if it's in router mode by its WAN port to the superhub LAN port.

In this mode C2300 LAN port will serve as network switch (extension) to your superhub.

Just make sure that C2300 DHCP server is disable when configured in AP mode.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 981

Replies: 1

Related Articles