Post beta firmware only showing one band?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Post beta firmware only showing one band?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Post beta firmware only showing one band?
Post beta firmware only showing one band?
2024-03-01 11:19:56 - last edited 2024-03-05 16:52:04
Model: Archer MR600  
Hardware Version: V1
Firmware Version: MR600(EU)_V1_210608

Hi.

 

I have been playing around with the beta version allowing manual band selection, however after installing the recommended update on the router it now only shows 4G LTE Band 3.  Is it still aggregating bands?   I'm still getting about 30Mb/s.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Post beta firmware only showing one band?-Solution
2024-03-05 09:09:10 - last edited 2024-03-05 16:52:04

  @amtrakuk 

 

For LTE CAT6 Router Archer MR600, Carrier Aggregation is supported and enabled by default. For the supported bands and band combinations, please check the specification of the product on our official website. However, whether and how the bands will be aggregated is related to the base station as well, we are unable to force it to work on 4G+ or force it to work on a specific band combination.

 

Therefore, when you select two or more bands, the MR600 might work on only one band as well. If your SIM card supports different band combinations in 4G+ mode, you could also try other supported band combinations.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Post beta firmware only showing one band?-Solution
2024-03-05 09:09:10 - last edited 2024-03-05 16:52:04

  @amtrakuk 

 

For LTE CAT6 Router Archer MR600, Carrier Aggregation is supported and enabled by default. For the supported bands and band combinations, please check the specification of the product on our official website. However, whether and how the bands will be aggregated is related to the base station as well, we are unable to force it to work on 4G+ or force it to work on a specific band combination.

 

Therefore, when you select two or more bands, the MR600 might work on only one band as well. If your SIM card supports different band combinations in 4G+ mode, you could also try other supported band combinations.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 382

Replies: 1

Related Articles