Archer BE800 needs to close and reopen PORT every few days
So I have a PLEX media center and i have the 32400 port open on my router (NAT Forwarding)
every few days I cannot access the PLEX remotly and i need to close the port and reopen it to make it work again.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, thanks for posting question on our community.
If the port forwarding doesn't work, please refer to the following troubleshooting steps:
1. Make sure the server is accessible from the internal network.
2. Make sure your router obtains the public WAN IP address, if your WAN IP is not a public one, port forwarding will not work. (CGNAT address is also private IP address that ranges from 100.64.0.0 to 100.127.255.255.)
3. Check the firewall settings of your server, make sure it allows traffic from the outside Internet.
You may check more detailed instruction following the FAQ.
- Copy Link
- Report Inappropriate Content
@Marvin_S I think you didn't really read the problem
opening the port working just fine. i can access plex media from out side my network easlly BUT every few days its stop working (also RDP)
and i need to go to the router admin panel and close the port and re open it to make it work again
its not related to firewall or any other problem out side the router.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, you may configure the Address Reservation for the PLEX media center then observe whether the issue remains.
If the issue remains, pleases share the screenshots of your port forwarding settings. Then we will consult the support engineers.
BTW, do you set up port forwarding for other devices and is there the same problem?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Marvin_S simple as that :
and i didn't fixed the problem
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 459
Replies: 6
Voters 0
No one has voted for it yet.