wireless no reconnection

wireless no reconnection

wireless no reconnection
wireless no reconnection
2024-06-13 18:37:54 - last edited 2024-06-28 12:08:43
Model: Archer VR400  
Hardware Version: V3
Firmware Version: 1.5.0 0.9.1 v00a1.0 Build 220321 Rel.60385n

"Smart Connect" if it is not active, power off-on or in case of power failure, the devices could not automatically establish a wireless connection again. It is necessary to make the connection manually on the devices. 

this has happened on more than 3 devices 

 

i'm using translation, I hope I was able to explain my problem :)

  0      
  0      
#1
Options
1 Accepted Solution
Re:wireless no reconnection-Solution
2024-06-14 03:42:07 - last edited 2024-06-28 12:08:43

  @Hseyin 

 

Hi, thanks for posting question here.

 The issue sound a little strange. If the "Smart Connect" is off, did you set different wifi names for 2.4Ghz and 5Ghz wifi band? Can you share the screenshots of your wireless settings?

May I confirm the devices you mentioned usually connect to 2.4Ghz or 5Ghz wifi band?

You may take a factory reset and reconfigure the modem royter to check again.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:wireless no reconnection-Solution
2024-06-14 03:42:07 - last edited 2024-06-28 12:08:43

  @Hseyin 

 

Hi, thanks for posting question here.

 The issue sound a little strange. If the "Smart Connect" is off, did you set different wifi names for 2.4Ghz and 5Ghz wifi band? Can you share the screenshots of your wireless settings?

May I confirm the devices you mentioned usually connect to 2.4Ghz or 5Ghz wifi band?

You may take a factory reset and reconfigure the modem royter to check again.

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 208

Replies: 1

Related Articles