Hi Folks,

I have an Archer AX73 v2.0 (Firmware Version: 1.1.0 Build 20240323 rel.70541(4555) )  connected to a TL-WPA8631P Powerline Adapter (Hardware and Firmware versions attached to thread.) in a mesh network. Everything works fine, but in my Tether app (Version 4.7.14 - latest version I believe) the menu item is displayed as OneMesh, when I think it should be displayed as EasyMesh. Before I had my Archer AX73, I had a Archer AX72 Pro connected to the same powerline adapter and I believe the app displayed EasyMesh, and this meant that from the main Network page, I could see the adapter in the same network as the router, tap on it, and see the clients that were connected to it. I could also see the adapter listed as a Satelite Device on the My Devices page. This is not the case with my AX73, the adapter only appears under the OneMesh tab, and I have to go into advanced settings to see which clients are connected to it. If possible, I would like to set the app up where I can see the adapter from the main network page - it's not a deal breaker or anything but it would be nice. I have checked the EasyMesh supported device pages and both of my devices are listed as supported. I would also like to point out that the menu items are displayed as EasyMesh on the web browser pages that manage the router and adapter via their IP addresses.

Any help to get this fixed would be greatly appreciated, if anymore details or clarification is needed, please just reach out.