TP Link Archer AXE75 as a Secondary Router Not Getting Full Speed

TP Link Archer AXE75 as a Secondary Router Not Getting Full Speed

TP Link Archer AXE75 as a Secondary Router Not Getting Full Speed
TP Link Archer AXE75 as a Secondary Router Not Getting Full Speed
a week ago - last edited a week ago
Model: Archer AXE75  
Hardware Version: V1
Firmware Version: 1.3.1 Build 20241101 rel.60873

I have a main router Huawei(HG8145V5) from my ISP and AXE75 as secondary router wired connected. Both devices have gigabit ports and they are conected with a cat 6 cable.

 

The main Router provides the paid speed of 500 Mbps. My desktop connected to one of the LAN ports of Huawey gets around 400 Mbps(there is not problem to get at 500 Mbps), But if I connected my desktop to one of the LAN port of the second router AXE75, It gets around 250 Mbps - 275 Mbps. It is the max speed that gets using second router AXE75. Using a cat 6 cable to test network speed.

Any ideas what is going on?

  0      
  0      
#1
Options
1 Accepted Solution
Re:TP Link Archer AXE75 as a Secondary Router Not Getting Full Speed -Solution
a week ago - last edited a week ago
QoS was configured to 300 Mbps, so speed was caped to that speed
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:TP Link Archer AXE75 as a Secondary Router Not Getting Full Speed -Solution
a week ago - last edited a week ago
QoS was configured to 300 Mbps, so speed was caped to that speed
Recommended Solution
  0  
  0  
#2
Options
Re:TP Link Archer AXE75 as a Secondary Router Not Getting Full Speed
a week ago

  @gatosempai 

 

Check if you have configured and idisable any QoS settings in the HomeShoeld feature and test again.

If this doesn't help configure AXE75 in AP mode (Case 1) and test again.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#3
Options