Need a firmware or way to force Ethernet connection
I have full TPLINK system, TPLINK Router (BE550 Wifi7), and TPLINK Deco BE25 as my mesh system. I have followed the right topology to setup my Deco.
Router-->Main Deco-->TPLINK Switch--> 3 x sattelite decos
All the points have Ethernet Connection. However, one of the sattelite simply refuse to connect through Ethernet and instead use Wireless Signal source. I have tried to change this Deco as Main Deco and then another Deco would be problematic where it uses Wireless Signal Source.
Is there a way or firmware to force the deco to use Ethernet?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Can I have the model number of the switch here?
Did you set Deco into "Access point" mode?
Please also refer to this link to submit the Deco APP log:
Here are some suggestions for your reference:
1. Please disable the "EasyMesh" feature on the Archer BE550.
2. Test whether the following topology helps:
Router-->Main Deco-->TPLINK Switch--> sattelite deco#1
--> sattelite deco#2-----> sattelite deco#3
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Hi, Can I have the model number of the switch here?
Did you set Deco into "Access point" mode?
Please also refer to this link to submit the Deco APP log:
Here are some suggestions for your reference:
1. Please disable the "EasyMesh" feature on the Archer BE550.
2. Test whether the following topology helps:
Router-->Main Deco-->TPLINK Switch--> sattelite deco#1
--> sattelite deco#2-----> sattelite deco#3
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Please also review the following forum topic to see if it applies to your situation: https://community.tp-link.com/en/home/forum/topic/655034
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 90
Replies: 2
Voters 2
