Easymesh Ax72<>AX10 on 5Ghz DFS channel

Easymesh Ax72<>AX10 on 5Ghz DFS channel

Easymesh Ax72<>AX10 on 5Ghz DFS channel
Easymesh Ax72<>AX10 on 5Ghz DFS channel
Yesterday - last edited 15 hours ago
Model: Archer AX72   Archer AX10  
Hardware Version: V1
Firmware Version:

Hi

I am planning to setup mesh wireless backhual between AX72 as main router and AX10 as satellite router on 5Ghz.

the AX72 5GHz is set on DFS channels which are not covered/supported by AX10.

would you please let me know if AX10 will work in this config?

  0      
  0      
#1
Options
1 Accepted Solution
Re:Easymesh Ax72<>AX10 on 5Ghz DFS channel-Solution
15 hours ago - last edited 15 hours ago

HI  @Roozen,

When building an easymesh network, the channels of the main router and satellite router need to be consistent.
Otherwise, when you select DFS channel for AX72, AX10 cannot successfully build 5Ghz backhaul. After the 2.4Ghz backhaul with AX72 components, the 5Ghz speed broadcast by AX55 itself will be very slow.
Therefore, it is recommended that you select auto for the channel settings of routers

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Easymesh Ax72<>AX10 on 5Ghz DFS channel-Solution
15 hours ago - last edited 15 hours ago

HI  @Roozen,

When building an easymesh network, the channels of the main router and satellite router need to be consistent.
Otherwise, when you select DFS channel for AX72, AX10 cannot successfully build 5Ghz backhaul. After the 2.4Ghz backhaul with AX72 components, the 5Ghz speed broadcast by AX55 itself will be very slow.
Therefore, it is recommended that you select auto for the channel settings of routers

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 50

Replies: 1

Related Articles