Archer C7 AC1750 v2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C7 AC1750 v2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C7 AC1750 v2
Archer C7 AC1750 v2
2015-03-09 13:40:03
Region : Malaysia

Model : Archer C7

Hardware Version : Not Clear

Firmware Version : Archer C7_V2_140318(Unifi & Maxis Fiber)

ISP : Maxis Fibre


I had a WDR-3600 it was working well with Maxis Fibre , then when I upgraded to the C7v2 problem happens.

Everytime I need to get into the modem and quick setup it before I can use it.
Sometimes I need to clone the address and sometimes I do not need to clone the address to get it right.

After few trials the modem would start working correctly until the modem is restarted.

Then I would nedd to quick setup it again on the clone/noclone option to get it working.

The old WDR-3600 can automatically connect back to the internet without quick setting it again.

Please guide me how to set the modem.
  0      
  0      
#1
Options
1 Reply
Re:Archer C7 AC1750 v2
2015-03-10 15:09:53
The modem you mentioned refers to C7?
When the problem happens, you can still login web interface of C7? There is no WAN IP address?
Did you configure it in the same as the instruction as below? http://www.tp-link.com/en/article/?faqid=703
On Network---WAN page, WAN connection mode is Connect Automatically?
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 805

Replies: 1

Related Articles