TD-W9970 with 2 PPPoE sessions
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TD-W9970 with 2 PPPoE sessions
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a BIG problem with TD-W9970 (version 1 and 2).
I configured 2 pppoe session on different UVLAN ID. The connections come up, user authenticated, IP address assigned etc.... every seems to work correctly.
When I have physical VDSL problem (line goes down) all the connections go down and comes up again when the VDSL line is restored.
If there's a problem on the uplink side of the ONU/DSLAM, so I don't have a VDSL physical down but an unreachability of upper network layer, one of two PPPoE session goes down (the one were the default gateway is set) and the second one remains up (connected state). I expected that both session went down!
I did some tests and it seems that on the second PPPoE session (the one without default gateway) doesn't sends out/use PPP LCP echo to check the PPP state.
This is a big problem because I need to reboot the TD-W9970 to let the second PPPoE works againg.
Any ideas ?
Thanks,
Davide
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a BIG problem with TD-W9970 (version 1 and 2).
I configured 2 pppoe session on different UVLAN ID. The connections come up, user authenticated, IP address assigned etc.... every seems to work correctly.
When I have physical VDSL problem (line goes down) all the connections go down and comes up again when the VDSL line is restored.
If there's a problem on the uplink side of the ONU/DSLAM, so I don't have a VDSL physical down but an unreachability of upper network layer, one of two PPPoE session goes down (the one were the default gateway is set) and the second one remains up (connected state). I expected that both session went down!
I did some tests and it seems that on the second PPPoE session (the one without default gateway) doesn't sends out/use PPP LCP echo to check the PPP state.
This is a big problem because I need to reboot the TD-W9970 to let the second PPPoE works againg.
Any ideas ?
Thanks,
Davide
