@Fae Sorry to comment on an old post, but I just bought the ER605 (TL-R605) to use in place of a TL-R600VPN. The R600 had the multi-Net NAT and it was easy to use as it had a stand-alone tab under...

Ok, I figured it out. The router needs to have a static route for that set of IP addresses with the next hop set to be the switches IP address. In case somebody runs into this issue in the future.

Hello, I have two DHCP pools set up in the T1600G switch on two Vlans 10, and 20. Below is the diagram showing the vlan 10 setup. The Router is setup to NAT the 10.10.10.0/24 subnet through a WAN...

I have followed all the steps found at the link below to try and set up a multi-Net setup exactly as described, except there is no static link between the the entities in the router (I want them kept...