@PHTP Hi, dude, good question. Check this treasure article in the KB on the top of the page.

@PavelV Hi, if you are using OC200 5.7.6, you can set the switch ACL with the Time range.

@RJ21KC Hi, how are you? I'm a little bit confused about how you found the data doesn't go through WAN1. Maybe you have the Link Backup feature enabled either, so that WAN1 is not online, you can...

@drigo Did you set the last port as Tagged? PC can not handle the tagged data if you set it like that. Change it to Untagged, and test it.

@damvalvr You can find the reset hole on the ER7206, use a pin to press it until the system light flashes. After that, you need to re-configure the router and set a new username and password for...

@BoboXX Hi, do you have any IPv6 enabled or related settings on thr router? Can you run the Wireshark when the laptop connect to your router? Is it the same result?