federerLV1Offline
Following: 0Followers: 1
Forums/ Switches
2016-12-08 14:39:17
Re:TL-SG105E cable used with TL-WA901ND
Crosstalk means your cable is damaged which cannot be used. So that is not the issue of switch or 901ND, the cable cannot work in any other situation. Change new cable is the method you need to do.
0HELPFULS
Forums/ Switches
2016-12-08 14:30:48
Re:SG1024 VLAN for nComputing Thin Clients
I attach each port for better understanding. And here i configure VLAN2,3,4 for each part you want. Then the configuration should like: VLAN2: port1,2,3; VLAN3: port4,5,6; VLAN4: port3,4,7,8,9,10;...
0HELPFULS
Forums/ Switches
2016-12-05 15:48:47
Re:configure trunk sfp
You could check whether your sfp port is independent port. If yes, you could double check which could see that port in VLAN settings. If not, you just configure port 9 with VLAN, it is also for sfp...
0HELPFULS
Forums/ Switches
2016-12-05 15:08:38
Re:Disable IGMP snooping for TL-SG108 ?
There is no way to disable it. It is just an unmanaged switch which couldn't make any change. And i cannot see any utility for this switch, where could you find it?
0HELPFULS
Forums/ Switches
2016-12-05 15:04:24
Re:SG2424 - IP Mode setting
After you configure DHCP mode, switch would get ip address from your former router. You need to check the ip address from your router, it could not be 192.168.0.1. And i also don't suggest that let...
0HELPFULS
Forums/ WiFi
2016-05-11 14:19:35
Re:RE: EAP 320 cannot switch to "pending" after "forget this AP" in EAP Controller
There is a beta firmware that i get from TP-Link support team. http://tp-link.com/resources/software/TL-EAP320v1_en_1.0.0_20160429-rel71477_up_tmp_signed.zip
0HELPFULS