Hi @physh, The PMF feature was supported since Omada Controller v5.7, which requires to upgrade the EAP device firmware to take effect. The previous firmware you used is not adapted to controller...

Hi @geoeap, Please follow the below steps: 1. Reset the AP, and make sure the default wifi name tplink_XXX is shown. 2. Create a password for an SSID with 2.4G and 5G both, and check whether it is...

Hi @dunxd ， I have no idea either, please keep an eye on the official website.

Hi @JotaUve, No, this EAP225 1.3.0 firmware is specific to the V5, and is NOT available for the V4.

Hi @A-anany00000000, Yes, you can use different models to create the point-to-point connection. CPE510 as the AP CPE and the CPE710 as the Client CPE.

Hi @HomeGeek23， This is a new pre-released version for the Linux controller, could you upgrade to it and test it again? Omada SDN Controller_V5.13.30 Pre-release