Thanks, I think that I will keep default factory settings then

GRL wrote @stealth23 Im not sure i follow you I just tested the following ACL to my spare NAS This sucessfully blocks the device from the WAN connection, but allows devices on my LAN to access it....

GRL wrote Problem with using IPGroup any is it will literally block any IP. WAN, LAN, All of them Is your WAN a static IP ? Also, try setting the "Source" as the NAS group EDIT: might need two rules,...

@GRL Hi GRL again, I'm back after resolving my network issue So I have a NAS at my LAN IP 192.168.1.3. I want to create a rule to have the ER605 block the NAS from Internet access (inbound and...

@HellBent HellBent wrote @stealth23 ISPs will often set the modem speed higher that the advertised speed and will boost your speed if bandwidth use is low across their network. I also know some ISPs...

Hi, by default the ER605 Firewall/Attack Defense/Flood Defense has all options disabled, which ones are good to enable? Also under Packet Anomaly Defense, Block TCP Scan with RST and Block Large Ping...