GRLLV5Offline
Following: 0Followers: 3
Forums/ Controllers
21 hours ago
Re:Hardware Controllers Omada SDN Controller 6.1 Pre-Release Firmware (Updated on 31st Dec, 2025)
@ceejaybassist Updated beta for OC200 hasnt been released yet
0HELPFULS
Forums/ Switches
Yesterday
Re:Omada Switch Pre-Release Firmware Adapting to Omada SDNC 6.1.X.X (Released on December 31th, 2025)-3
@Ethan-TP All my switches have been updated to this batch. All my siwtches created ACL and IP Group configuration failures after the update. "Apply Again" didnt clear them, but i was able to...
0HELPFULS
Forums/ Switches
Yesterday
Re:Omada Switch Pre-Release Firmware Adapting to Omada SDNC 6.1.X.X (Released on December 31th, 2025)-1
@Ethan-TP All my switches have been updated to this batch. All my siwtches created ACL and IP Group configuration failures after the update. "Apply Again" didnt clear them, but i was able to...
0HELPFULS
Forums/ Switches
Yesterday
Re:Omada Switch Pre-Release Firmware Adapting to Omada SDNC 6.1.X.X (Released on December 31th, 2025)-2
@Ethan-TP All my switches have been updated to this batch. All my siwtches created ACL and IP Group configuration failures after the update. "Apply Again" didnt clear them, but i was able to...
0HELPFULS
Forums/ Gateways
Tuesday
Re:Conflict "Enable Application Optimized Routing" VS "Policy Routing"
@avpopov1977 Application Optimised Routing and Load Balancing has NO EFFECT on any IPs or Networks that are set by policy routing to use a specific WAN. Policy routing enforces those IPs or Networks...
0HELPFULS
Forums/ Gateways
Tuesday
Re:WAN GW address is outside network address
@MiKyMK79 Technically, the error is correct, the gateway IP is outside that mask and then by industry standards, is not reachable as it sits outside the mask scope You can probably immediately fix...
1HELPFULS
123...