@lukass2000 Its all about tuning the spread pattern of the antennas - and also in the case of the HD - having chipset capable of FAR more connected clients on each radio

@Tournas You can also try making an IP-Port-Group with just the port - if you dont add a subnet it applies to 0.0.0.0/0 (any IP) and use that as the source and destination IP_any in a switch ACL, i...

@Cyberwasp This model switch only supports Static LAG If your bonded NAS ports are configures as LACP ( sometimes called "Active") LAG, they are not compatible standards and a loop will form, causing...

@brute4c As above, this is all achieveable easily. Internet restriction ACLs can only work properly on the gateway since that is the exit point of the network The rest can be done with switch ACLs...

@Dr_Marty You can achieve exactly what you want, but its both untidy and in a different way, better If you are using a seperate Omada switch for your WAN trunking and tagging management, you can...

@Artur.Aragao ah, thats actually a different problem then. Rate limits set higher than around 220mbit dont work, the EAP wont go any higher than 220ish when rate limit is enabled on a SSID Prohibit...