@downtheroad As i indicated, my 8411 runs a pretty complex network with tons of traffic, IDS turned on, DPI turned on, 3 WANs. Ignore the big spikes, i was configureing some stuff and rebooting - the...

@downtheroad Disconnect your controller form the network. Log into the router GUI directly via its IP (you can only do this with the controller disconnected) Initiate a factory reset from the GUI....

@BCCHowdy Switch ACL rules are not what you want, you want gateway ACL rules. Switch rules are not stateful, therefore thay are unable to account for a situation like Device A cannot access device B,...

@Vincent-TP My OC200 v1 running Nov 8th prerelease rebooted by itself tonight for no reason. I was in the interface looking at data usage graphs and BAM, no response.... I could connect to all other...

@n0izee I have my OC 200 on its very own, basic TPlink "easy smart" poe switch (SG105PE) with POE recovery set so that if the switch cant ping the IP of the controller on its port, it waits a minute...

@Vincent-TP This latest version on OC200 v1 left my ER8411 in a "Disconnected" state and requiring a power cycle. All other switches and EAPs were re-adopted normally. No WAN settings being wiped...