@ingeborgdot My simple advice is to keep 192.168.0.x/24 VLAN1 as your 'management' network, at least for the Router and attached switch. The reason is if you ever have to default your router it will...

@Arshad007 You switch is only showing 3 ports as active, 1,2,8 and none of them as uplink. It also looks like your controller (software?) is connected to the 2008 as well. If I do the math, two...

@BLite Hi John, I had Starlink for a few months and then FTTH came knocking, I couldn't say no. But, that said, I did have a VPN knocked up between my Starlink site and another cable ISP site for...

@titocarnale Almost 3 weeks since the last power bump....

@titocarnale FWIW I'm running the same setup (OC200 5.1.7, ER605 1.2.0) with the same IP's for router and switch and I do not have this issue. ** Turns out I do, masked by glitchy power grid in...

You tried the use the controller to do it right? No, you must basically factory reset the device and use it's native (local) web interface to try the downgrade.