@SCBJr Have you confirm the LED is enabled in the controller? Or even maybe toggle it on/off?

@RobertMEF So here's my main question... Can you confirm you will be saturating 1G speeds while in production? Also, have you bypassed the Omada router and tested the ISP speed connected directly?...

@dirmwtlsf You can... but they would need to be at the same nic speed on each side. I would aggregate two 10G ports on the main switch. Then set the same setting on the 2nd switch and plug up the...

@dirmwtlsf Well, it comes to affordable switches... most "cost-effective" vendors do not stack. That's a big vendor feature. (cough) If you're looking at combining ports, let's say two 10G ports to...

@Kash01976 I would follow @Virgo advice. I had a client with the same issue. After the forget and full reset on the AP. I had to log into the AP and set the IP address of the controller. that stuck.

@Chartone Are you trying to combine both WAN ports? If so that is "Binding" and the ER605 doesn't do that. Load Balancing and Binding are two different functions. If you want to bind, then you would...