@Lectron8 When the AP drops, does POE on the switch turn off too? Do you have meshing enabled? If so, does this AP try to mesh on its own? (good test) Trying to figure out if it could be a bad cable...

@Chris-Cross Yea - so you kinda didn't answer my question... Anyway, good luck with your setup, my dude!

@kraal I dont think that possible with Omada. You would need to edit the controller code to point to the firmware/software server. Or find the URL of that server and replicate it in your local DNS...

@Lectron8 Just for giggles, have you confirmed the signal strength of the active connected clients during these issues? We need to see where they are sitting at during these issues. This is step 1 in...

@Chris-Cross 2 things... do you have WAN Settings Overrides disabled before adopting the 8411? BY chance, if the fritz box and the 8411 on the same subnet?

@joems I think I read your post wrong... but You can access the controller from another PC... You will need to enter https://IP OF THE CURRENT PC:8043 in Chrome and you can log in. May have to edit...