@iampegram check the timing for log --> alert --> notification. See if there is a hidden nuisance timer that requires the issue to persist for 5 minutes (or whatever time) before it is logged......

@Hank21 Firmware are up to date per Omada distribution. OCC200 2.0 5.7.6 2.7.7 Build 20221206 Rel.58608. The disconnects DO get logged, just happens after a 5 minute delay. A disconnect that is...

@PHTP As you widen the BW, the radio output power is spread over that spectrum, resulting in less output power/MHz. Similarly, the receiver sensitivity drops. I'm thinking you would require a lot...

@paulrob I think it is simply to replace the port on the gateway that the OC200 occupies. I found myself short one Ethernet port in my initial deployment, and plugged an EAP110 into the OC200....

Trying to understand the usage/traffic statistics, as it doesn't seem the various numbers add up. All data consumption is wireless thru 7 access points (EAP225-outdoor, EAP245). There is no...

Despite Notifications in Omada being checked for Event and Alert under Device Connected and Device Disconnected, Omada never shows any Disconnected status! Only get CONNECTED status events. Omada LOG...