@RamtinR So how can the switch be configured within the controller if it's resetting the IP to 192.168.0.1? Why would the adoption place the switch on a network it can't communicate with? I'm fine...

That didn't work...Switch still reverting to 192.168.0.1 during the Omada adoption process...

The only relevant post I've found so far seems to be this one: https://community.tp-link.com/en/business/forum/topic/583776 I had my SSH port set to a non-standard port when I tried to adopt this...

Omada adoption of this TL-SG2428P switch is a real issue...I've configured this switch with a Static IP so that it properly works on my LAN. I've also set up LACP LAG between this switch and my...

I have the same issue...EAP670 + EAP610-Outdoor. If I enable power optimization on all bands, the scan always fails (and takes over 20 minutes to run). No issues with channel optimization, and the...

How long is that Cat5e cable running to your bedroom (ballpark guess)? Cat5e SHOULD be ok up to 300 ft in length, but that's not always the case. Patch cable quality is key, and you may find out that...