@frankz66 The drop in speed is usually an issue with wire 4,5,7 or 8 continuity and I think power can be supplied using wires 1,2,3 and 6 or using wires 4,5,7 and 8. It seems odd that the switch...

Hi @frankz66, Based on the information provided, my best guess is that the cable is not making a good connection where it plugs into the AP. Check the port on the AP for debris or damaged/misaligned...

@op_pikachu, Yep, it might be a proxy config, which you may or may not be able to disable or bypass. You can also try using ssh/cli to change the https port to something other than 443. The best CLI...

@op_pikachu, can you ping the switch IP? If ping works... If you're using multiple VLAN, it could be the traffic is not on the VLAN with admin status set, or maybe it's unchecked. Or maybe an access...

Hi @op_pikachu, It sounds like the switch is missing the default gateway. Get the default gateway from one of the other hosts and try adding that IP for the "Next Hop" in the steps below... Go to L3...

Hi @JonnieBeGood, Unfortunitly, it doesn't look like the POE injectors you have will work. The ones you listed are passive but the EAP-615 Wall requires an active (802.3at or 802.3af) injector. If...