I have a BE22 as a main unit with a pair of X10s working as a mesh network. The BE22 is connected directly to my ONT using PPPoE connecting to my ISP. The guest network used to work fine when I had...

Thanks @Wayne-TP Signal strength shows -30, very strong. Ping return time worst-case is 14.3ms. The firmware TP Deco and H500 and both running on the latest versions.

My H500 hub keeps going offline every couple of weeks or so. I find it with Green and Red alternating lights. A power-cycle immediately resolves the issue; but I would like to know how to stop this -...

@tHolkien1 The tp-link solution was that camera notifications have a 1 minute cooldown delay to prevent these double notifications from the same camera, and they recommended using the built-in...

@Solla-topee Hi. 1. Notifications are set to 'off' in the camera settings. 2. No, I am not using Tapo Care, the camera has been installed for 3 months and connected to an H500 hub. 3. No. It appears...

I use two detection zones to create a polygon around the area in my garden being monitored (avoiding a busy pavement and neighbours). I have AI person detection enabled, and have created an...